Posts

Showing posts from June, 2016

Manufacturing and assembly center fountain in white marble with an octagonal pool macael

Image
This fountain was designed and manufactured fully customized, from reference sources models our catalog, but completely adapted to the preferences and measures provided by the customer.

It is a fountain of white marblewhite marble with honed finish, 40 cm in height and diameter dish of 105 cm, surrounded on its perimeter by an octagonal pool diameter of 250 cm also made of white marble macael. Its base is recessed to be fitted with an engine inside, to operate the circuit closed source water, and that is hidden and accessible through a marble top built into the base assembly source .

We show you some pictures of the manufacturing process of the source:








After the manufacture of the fountain we walk and work with our staff we started with on-site assembly.

Here are some pictures of the assembly process:















Buchinger Clinic: Recovery exterior terracotta floor in very bad condition

Image
This work was conducted at the Buchinger Marbella Clinic on the terrace next to the restaurant.

As can be seen in the pictures below, you can see the poor condition in which he found:




The procedure was first to carry out a deep etching process for removing mildew stains and other debris that had much of the mud floor of the balcony, especially the part that was by the tree.

We leave you some pictures of the process :




Once the floor is clean and dry this is the state in which I remain, prior to the application of protective treatment for outdoor use:








The treatment was applied wet finishing effect does is highlight and intensify the natural coloring slab of clay; and this was the final finish obtained after completion of treatment work :